|Our motto: "under-promise...over-perform"|
Simple, straightforward and low shipping rates for these KWC parts.
Q. "How do I measure the length of my pull-out KWC handset (just the handset, not the entire spout) to determine if I need a 5-inch or a 7-inch sprayhead?"
A.The handsets are measured from the threaded end (where your hose screws on) to the tip of the spout, so you should be able to determine the spout you need by unscrewing it from the hose and measuring it from end to end (either 5 inches or 7 inches).
Q. "Then how do I measure the length of the entire spout (not just the handset)?"
A.The measurement from the center of the faucet (straight down through the handle) to the center of the outlet on the handset is considered the length of the spout itself. If that measurement is 7 inches, then you need the 5-inch handset; if the measurement from the faucet center to the center of the outlet is 9 inches, the 7-inch handset is the correct replacement.
We hope that we have helped you on this page with KWC parts,
and thank you for helping to make PlumbingSupply.com® the most famous Internet plumbing supplier.
Is there something else that you are looking for?