The DispenserPlus soap/lotion dispenser is a must for every shower or tub. Clean up the clutter and save money, too with a DispenserPlus from PlumbingSupply.com.

Installing the DispenserPlus is very easy!

To mount with adhesive (included) Select a location most suitable for your use. Thoroughly clean and dry the wall surface and wall-mount bracket. Apply the adhesive to the smooth side of the wall-mount bracket, not the dispenser. Allow the adhesive to set for about 5 minutes. Then place the wall-mount bracket in the desired position. Wait up to 48 hours (depends on humidity and temp conditions) before hanging the Dispenser Plus on the wall-mount bracket. Check the wall-mount bracket to be sure it is securely fastened. Slide the Dispenser Plus into the wall-mount bracket.

Dispenser Plus - click here for product and ordering information

To mount with screws (included) Select a location most suitable for your use. Hold the wall-mount bracket in the desired position and mark the screw-hole locations. (We recommend that screw positions be aligned with the grout between tiles, if possible). Drill a 3/16" (5mm) hole for each of the two locations. Insert the plastic expanders into the screw holes. Position the wall-mount bracket and secure with the screws provided. Slide the Dispenser Plus onto the wall-mount bracket.

No more spilling expensive shampoos, lotions, etc.

No more consolidating the contents of half-empty bottles. These European Dispensers originals are made in Italy. Made from durable polycarbonate - all rust proof parts. 12-ounce capacities in each reservoir. Rubber tips are replaceable (no need to buy totally new unit). The internal reserve tanks allow for continued use, though the chamber may appear empty. Each time the special pump design delivers clean and measured doses, and a special valve re-absorbs the final drops to eliminate waste.

Save money AND help save our environment. Buy in bulk at your local co-op, etc. and fill your dispensers instead of buying throw-away little plastic bottles.